The ProFroster - LIMITED EDITION BABY PINK [PF-002]
end of line stock
JUST ARRIVED - Limited Edition Baby Pink Profrosters - Only Limited Number Available. Once they are gone this colour will not be returning.
The ProFroster - Frosting your cakes will never be the same.
Creating a level cake is difficult and time consuming. The ProFroster is a frosting tool that allows you to get clean straight edges for cakes up to 8" high. For use with Buttercream, Frosting and Ganache.
If you are a Cake Maker the ProFroster will save you time and headaches.
If you are a hobby cake maker the ProFroster will make your cakes more elegant.
HOW TO ACHIEVE SHARP EDGES ON YOUR CAKE :
Step 1: Always start with a properly trimmed and layered cake (by cutting off the center bump from your cake). Crumb coat your cake and put it in the fridge for about 30 min or more to create a hard crust, the harder the crust the better.
Step 2: Frost your cake with a good amount of frosting (don't worry it will mostly scrape off) on all sides. Make sure that the frosting goes above the height of the cake on all edges.
Step 3: Put the Bar (base; see images below) of the ProFroster against your cake board as you would your bench scraper, and measure where the riser should be.
(The reason why you put it against the cake board is because the cake board is always slightly larger than your cake in diameter, this allows enough room for a good amount of frosting on the outside of the cake. By aligning the ProFroster to the edge of the cake board, the top of your cake will be the same diameter as the bottom of your cake, which is what gives you straight lines all the way down the sides of the cake. In the above video I am using an 8" cake board with an 8" cake. If you want more frosting on the outside of the cake then go up to a 9" cake board)
Step 4: Adjust the Riser height to meet with your frosting / cake height, and allow the pins to lock into place (see images below on how to assemble the ProFroster). Don't move your hand / grip. Start rotating the cake stand but keep the ProFroster stationary and start scraping.
Step 5: After your first pass, if you have any gaps fill them in with frosting and rotate / scrape again. You may have to do this several times to make sure that all your gaps are filled in.
Step 6: Smooth the top of your cake where the Riser has left a mark, if any, with your spatula.
The cleanliness of your edge will depend on the consistency of your frosting, the thicker the frosting the better...if you use a frosting like ganache, the edge will be sharper.
Made in the USA
A life saver! by Alex Bond on 05/29/2017
My best purchase from Cakes Around Town yet! I love my pro frosted .. It has made my work a lot easier!